radius of curvature

1. To Solve Radius of Curvature on the Cam Profile with Translating Follower by Means of Substitute Equivalent Linkage Instead of Higher Pair
   高副低代法求直动从动件盘形凸轮廓线的曲率半径
2. Polyethylene ducts shall not be used when the radius of curvature of the tendon is less than9000mm.
   力筋弯曲半径小于9000mm时，不得使用聚乙烯管。
3. The lens radius of curvature could be minished with the laser output enhanced.
   透镜曲率半径随单位面积输入能量增加而减小。
4. The empirical expressions of solid phase friction coefficient for horizontal pipe, rising pipe and bends with different radius of curvature were established.
   分别对水平管、上升管、以及不同曲率半径的弯管等建立了相应的固相摩擦因数经验式，得到了一整套计算喷吹管路压降的模型。
5. The error in radius of curvature as well as the equivalent refractive index should be considered in the corneal vergence measurement for eyes after refractive surgery.
   屈光角膜手术后人眼角膜光焦度的测量，不仅要考虑等效折射率带来的误差，也要考虑角膜曲率半径测量误差造成的角膜光焦度测量误差。
6. Based on the corneal data, the effects of equivalent refractive index and error in radius of curvature on the corneal vergence measurement after refractive surgery are studied theoretically.
   在角膜数据的基础上，从理论上分析了等效折射率和曲率半径测量误差对屈光手术后角膜光焦度测量的影响。
7. Evaluation of respiratory influence on interventricular septum by radius of curvature
   曲率半径法研究呼吸对室间隔运动的影响
8. Enter the radius of curvature, as measured from the inside of the stalls.
   输入曲面的半径，从隔栏内量起。
9. Natural Parameter Method is a kind of new method of wellbore trajectory computation succeeding Cylinder Helix Method ( Radius of Curvature Method) and Minimum Curvature Method.
   自然参数法是继圆柱螺线法和最小曲率法之后提出的一种测斜计算新方法，在井眼轨迹设计与计算中有着广泛的用途。
10. A new method for computing the radius of curvature of cam with oscillating roller follower
    摆动滚子从动件凸轮廓线曲率半径计算的新方法
11. The radius of curvature of the highlighted face is too small for blend to fit. Try a smaller blend radius using Info/ Minimum Radius.
    如果因为面的曲率半径太小而不能创建圆角，则会发生以下错误。高亮显示有问题的面。
12. Mathematical formulas are derived comprehensively and systematically for the profile coordinate, pressure angle and radius of curvature of the cylindrical cam with an oscillating roller follower.
    推导了摆动滚子从动件圆柱凸轮廓线、压力角及廓线曲率半径方程，讨论了该种凸轮机构在各种运转情况下与之相适用的方程。
13. On the basis of summing up conventional testing methods for the radius of curvature of optical sphere, a novel method using laser tracker and interferometer is proposed.
    在简要总结各种检测光学球面曲率半径方法优缺点的基础上，提出了利用激光跟踪仪和激光干涉仪测量光学球面曲率半径的新方法。
14. Roundness depends on the sharpness or radius of curvature of the edges.
    浑圆度取决于边角的锐度或曲率半径。
15. Precision analysis of measurement of radius of curvature by interferometer
    干涉仪测量球面曲率半径的精度分析
16. As a classical experiment, Newton ring experiment is usually used in measuring the radius of curvature of a lens.
    牛顿环实验是大学物理实验中的一个基本实验，目前的实验只是用于测透镜曲率半径。
17. The minimum radius of curvature of the tendon in the anchorage zone for non-bonded tendons should be given in the appropriate European Technical Approval.
    锚固区无粘性钢筋的最小弯曲半径值在相应的欧洲技术认可中应该给出。
18. The cutting edge's radius of curvature can be estimated.
    断面曲率半径是可被预估的。
19. That is to say, the radius of curvature of the cornea is inversely proportional to age.
    男女均随年龄的增长，角膜曲率半径大致呈递减趋势，即：角膜曲率半径与年龄成反比关系。
20. Also given for the pipe lowering method are the allowable span, elastic radius of curvature, elongation and minimum excavation length> with the construction requirements and points needing for attention proposed.
    并对沉管法在施工设计中的允许跨度、弹性曲率半径、伸长量及最小开挖长度等要素作了介绍，同时指出了施工中的具体要求和注意事项。
21. Analyzed to the strength equilibrium condition with horizontal curves due to calculate of radius of curvature, deduction calculate of formula was precise.
    针对由力的平衡条件确定的曲率半径计算方法做了进一步的分析研究，推导出了较为精确的计算公式。通过实际例子的计算，进一步验证了计算公式的准确性。
22. In this paper, the pressure angle and minimal radius of curvature of cam mechanism with swinging roller follower are discussed in details.
    本文对摆动从动杆盘状凸轮机构的最大压力角和最小曲率半径问题进行了详细的讨论。
23. This paper presents a formula of the permissible radius of curvature for bent optical fibers.
    本文导出了光纤波导的允许曲率半径计算公式。
24. Research the basal concepts and formulas of coordinate conversion, the formulas of the radius of curvature in a normal section, the meridional length and the latitude of pedal are given.
    对坐标转换的基本概念和基本公式做了研究，给出了法截线曲率半径、子午线弧长和底点纬度的解算公式。
25. This paper calculates the radius of curvature of lens exactly by using average method to measure the diameter of Newton's rings.
    本文通过用平均值法测定牛顿环的直径，解决了牛顿环直径测不准的问题，从而精确地计算出透镜的曲率半径。
26. On the basis of this using the radius and the feed of the rigid axle which are the main factors of influence on the radius of curvature after springback, a modified bending springback formula has been obtained and an example of calculation given.
    在此基础上，利用回弹后曲率半径的主要影响因素即刚性轴半径和进给量，对已有理论结果进行了修正，得到了滚弯回弹理论修正公式，并给出了具体算例。
27. The choice of the spheral mirror's radius of curvature also affects the diffraction loss of the rectangle resonator.
    凹面镜的曲率半径的选择也对腔的衍射损耗有影响。
28. Firstly A method to calculate radius of curvature was also extracted in this paper.
    文章对于有限元模拟过程中实体单元离散的板材曲率计算问题进行了研究，提出了计算曲率的方法。
29. Abstract: The radius of curvature of light beams is an important parameter of describing the wavefront properties.
    摘要：光束的等相面曲率半径是描述光束波前特性的重要参数。
30. Focusing on the research of some important design parameters impacting the carrying capacity of the bearing, including radial clearance, contact angle and groove radius of curvature coefficient, a detailed analysis was given, and the corresponding bearing design recommendations were presented.
    着重对影响轴承承载能力的重要设计参数径向游隙、接触角、沟曲率半径系数等进行了仿真，并给予了详细的分析，提出了对应的轴承设计建议。

noun

1. the radius of the circle of curvature